Husqvarna K970 Mark III
16" Concrete Saw Hire
A professional petrol power cutter for concrete, masonry, brick and asphalt. Supplied with a 400 mm diamond blade, water connection for dust suppression and a full safety handover before you leave the yard.
- 4.8kW petrol power cutter — no leads, no generator
- 400 mm / 16" diamond blade supplied
- 155 mm maximum cutting depth
- 11.6 kg — comfortable one or two-handed cutting
- Wet cutting water connection for dust suppression
- Active air filtration for long service intervals
- Cuts concrete, masonry, brick, pavers and asphalt
- Blade diameter
- 400 mm / 16"
- Maximum cutting depth
- 155 mm
- Power output
- 4.8 kW
- Fuel
- Petrol (2-stroke mix supplied)
- Weight
- 11.6 kg
- Dust suppression
- Wet cutting water connection
400 mm diamond blade supplied with 2 mm wear included. Blade wear beyond 2 mm is measured on return and charged at cost.
0488 006 868Operator Manual & Safety Information
Before operating the Husqvarna K970 Mark III, all hirers and operators must read and understand the manufacturer’s operating and safety instructions and receive the required MOR-LEC HIRE equipment handover.
View Husqvarna K970 Mark III Operator ManualImportant: Concrete cutting equipment can cause serious injury if used incorrectly. Operators must follow all manufacturer instructions regarding personal protective equipment, blade selection, blade inspection, guarding, kickback, dust suppression, refuelling and safe cutting procedures. The manufacturer’s operator manual takes precedence over any simplified information displayed on the MOR-LEC HIRE website.
Pre-hire safety checklist
MOR-LEC HIRE completes and signs this checklist with you at handover.
- Correct 400 mm blade fitted
- Blade inspected for damage
- Blade suitable for material being cut
- Blade direction correct
- Blade guard fitted and operating correctly
- Water/dust suppression system checked
- Throttle and stop controls checked
- Fuel system checked for leaks
- Machine visually inspected
- Customer instructed on safe starting procedure
- Customer instructed on kickback hazards
- Customer instructed on correct cutting technique
- Required PPE discussed
- Operator manual provided